中国DOS联盟

-- 联合DOS 推动DOS 发展DOS --

联盟域名：www.cn-dos.net 论坛域名：www.cn-dos.net/forum
DOS，代表着自由开放与发展，我们努力起来，学习FreeDOS和Linux的自由开放与GNU精神，共同创造和发展美好的自由与GNU GPL世界吧！

游客: 注册 | 登录 | 命令行 | 会员 | 搜索 | 上传 | 帮助 »

中国DOS联盟论坛 » DOS媒体世界 & 网络技术（多媒体室） » 请教一下这个网卡在DOS下怎么加载，？

lisen5888
初级用户

积分 107
发帖 1
注册 2005-5-29
状态离线

『楼主』: 请教一下这个网卡在DOS下怎么加载，？

For use on PCs running DOS version 6.22 only.
To use to login to a Novell Netware Server use the Novell ZENWorks Starter Pack
to setup and configure your PC.
To login to NETBEUI/NDIS environments please use Novell's ODINSUP.COM protocol
as a link between the B44 DOS ODI driver and the NETBEUI/NDIS protocols.
CUSTOM KEYWORDS in driver v1.10 for net.cfg:
BUSNUM
DEVNUM
MODEL
LINESPEED
DUPLEX
The first two keywords are used concurrently and have been included for
manufacturing purposes.  Do not use them unless you are familiar with PCI
device configuration.
These two keywords are needed if multiple NetXtreme boards are on a system
and (a) specific NetXtreme adapter/s need to be loaded in specific order.
BUSNUM specifies the PCI bus number and DEVNUM specifies the device
number given to the board when configured by the PCI BIOS.
A PCI device scan utility is needed to find this info.
The values are in decimal.
Example:
if a PCI scan utility displays card 1 at bus 4 and device 11(hex) and
card 3 at bus 3 device 13 hex then the following would be put into net.cfg
to load card 3 first and optionally load card 1 second:

LINK DRIVER B44
  BUSNUM 3
  DEVNUM 19 (13 hex = 19 decimal)
LINK DRIVER B44
  BUSNUM 4
  DEVNUM 17 (11 hex = 17 decimal)

The MODEL keyword is for loading the driver only on the first NIC found
that has a sub-vendor ID (SVID) that matches the one set in MODEL. The driver
will ignore all other NICs that do not have a matching SVID.
MODEL expects a decimal number.
Example:

LINK DRIVER B44
            MODEL 5348
LINESPEED:
This decimal parameter, 10/100, specifies the speed of the network connection.
DUPLEX:
This string parameter, HALF/FULL, specifies duplex mode on the ethernet controller.
The Linespeed parameter must be set when this keyword is used. If neither the Duplex
nor the Linespeed paramaters are specified the ethernet controller will default to
autonegotiate mode.
Example:

LINK DRIVER B44
  LINESPEED 100
            DUPLEX FULL

2005-5-30 00:00

请注意：您目前尚未注册或登录，请您注册或登录以使用论坛的各项功能，例如发表和回复帖子等。

可打印版本 | 推荐给朋友 | 订阅主题 | 收藏主题

论坛跳转: